The following are areas inspected during an S&R Home Inspection.



Structural Components:
 Foundations, Columns, Beams, Basements, Crawl Spaces, Floor, Wall and Ceiling Structures, etc.


Roofing Components:
Roof Structures (rafter, truss, etc.), Roof Coverings (asphalt/fiberglass shingle, cedar shake, tile, slate, metal, roll roof material, flat/built-up, etc.), Gutters, Downspouts, Flashings, Skylights, Chimneys, etc.


Exterior Components:
Siding (brick, brick veneer, vinyl, composition board, stucco, cement shingle, wood, cedar, stone, steel, etc.), Garages, Carports, Decks, Patios, Porches, Driveways, Walks, Fences, Soffits, Fascias, Retaining Walls, Basement Stairwells, Window Wells, Lots/Grounds, Water Spigots, etc.


Interior Components:
Ceilings, Walls, Floors, Doors, Windows, Kitchens (installed ranges, range venting, dishwashers, microwaves, food disposals, etc.) Baths (sink/vanities, tub/showers, toilets, etc.) Laundry Facilities (washer/dryer power supplies, washer drains, tub sinks/drains, dryer venting, etc.), Fireplaces, Stairs/Handrails, etc.


Heating & Cooling Components:
Forced Air, Boilers, Radiant Heat, Heat Pumps, Central Air, Ductwork, Registers, Radiators, Thermostats, Filtering System, etc.


Electrical Components:
Electric Service Entrance, Service Panels and Sub Panels, Circuit Breakers, Fuses, Grounding, Branch Circuits, Outlets/Wall Switches, Ground Fault Circuit Interrupters(GFCI), etc.


Plumbing Components:
Main Supply Lines, Distribution Lines, Drains, Traps, Vents, Faucets, Shut Off Valves, Pressure Regulators, Water Heaters, etc.
 

Attic Components:
Insulation, Ventilation, Vapor Barriers, Attic Fans, Whole House Fans, Plumbing Vent Pipes, Furnace Flues, Chimneys, etc.